Plasma/Active/VirtualBox

Before you can start the image via VirtualBox, please configure the virtual device as below.

VirtualBox OSE Manager

  Settings
  ├── General
  │   └── Basic
  │       ├── Name --> e.g. Plasma-contour
  │       ├── Operating System --> Linux
  │       └── Version --> Linux 2.6
  ├── System
  │   ├── Motherboard
  │   │   ├── Boot Order
  │   │   │   ├── CD/DVD-ROM
  │   │   │   └── Hard Disk
  │   │   └── Base Memory --> 1024MB
  │   └── Processor
  │       └── Enable PAE/NX
  ├── Display
  │   └── Video
  │       ├── Video Memory --> 128 MB
  │       └── Enable 3D Acceleration
  └── Storage
      ├── IDE Controller
      │   └── IDE Secondary Master
      │       └── Set up the virtual CD/DVD drive
      │           └── <ISO image>
      └── SATA Controller
          └── Hard Disk
              └── Set up the virtual hard disk
                  ├── Dynamically expanding storage
                  └── Virtual Size --> 8.00 GB

Please note, if you'd like to install our live image to an VirtualBox hard drive, you have to remove the live image from the virtual CD/DVD-ROM after installation. This will be done after Power off the machine via VirtualBox OSE Manager.

  Settings
  └── System
      └── Motherboard
          └── Boot Order
              ├── CD/DVD-ROM --> disable
              └── Hard Disk

Once Mer/Plasma Active is installed, you may want to enable the mouse cursor.